DISKs are gone after shutting down and replace an FC card

[Saud]

hi there

i had issue with one of MY FC cards on T4-2 servers so system team replace it and start the machine but when launch FORMAT command so i dont see my disks. i have checked at the Fabric switch so WWN numbers are visible and zones are ok and after checking fcinfo hba-port so it also saying that SFPS are online, then i run commnds like devfsadm -C or devfsadm again and again but disks are still not visible
pl anyone can tell me what else i should check to get the DISKS back

regards

[ErmanArslansOracleBlog]

Hi,

so your issue is on Solaris.

Check this MOS note , it seems similar to yours -> Hard Disk Not Seen In format After Physical Replacement (Doc ID 2027630.1)

[Saud]

Hi

i dont have access to that doc but any way i got disks back as there were soem issue on the storage side now i am trying to start crs but couldn't do it as the same error CRS
-bash# ./crsctl start crs
CRS-4640: Oracle High Availability Services is already active
CRS-4000: Command Start failed, or completed with errors.

even used these commnads like
[root@rac1 bin]# ./crsctl start resource crs
CRS-4535: cannot communicate with cluster ready services
CRS-4000: Command Start failed, or completed with errors.

then search the web found this
# ./crsctl start cluster

but it took a lot of time and didn't do anything

after thet i reboot the machine twice but didnt work and my crs is not started

plz guide
regards

[Saud]

issue resolved of CRS. it was the persmission on DISKS which was causing the problem

[ErmanArslansOracleBlog]

Good for you.
Thanks for the info Saud.